While I was busy saying that my sequencer helped make the SX-150 into more of a viable sound-making tool, this guy was making an ass out of me.

Ok, so that was a couple years ago, but it's still awesome, and it's great to see the SX-150 being used as a real instrument. I still think it's pretty hard to control with just the stylus and a sequencer gives you more to work with, but this is pretty awesome.

This is the big one. Following up on Part 1 -- where we took control of the SX-150 pitch control, and Part 2 -- where we built on that to have basic sequencer note-on/note-off control, Part 3 is where it comes together with a hardware-and-Arduino based 4-step sequencer for the SX-150!

Read more »

[Update: This article has been continued with Part 3]

Back again with the next phase in the Arduino-based sequencer for the SX-150 project. Boy, I need a catchier name for that. I'll work on that.

If you recall, at the end of Part 1 I had used a digital potentiometer to replace the stylus-and-strip control for the Gakken SX-150 Analog Synthesizer.

In this next stage of the project, I'm going to replace the digipot with one that has a wider range, then extend my circuit and my source code to let the arduino directly play individual notes without having to worry about resistance values.

Read more »

[Update: This article has been continued with Part 2 & Part 3]

Out of the gate with the first blog post of the new year, and this is one I'm particularly excited about because it gets me to the point of starting to hack things that make cool sounds. I've long had an interest in experimental electronic music, so I'm excited that I have something to share in that arena.

In the past I've mentioned my wonderful wife (who is wonderful, if I didn't say so), and this Christmas she doubly earned that distinction by buying me a Gakken SX-150 Analog Synthesizer. As far as a 'kit' goes, it isn't much to speak of -- just installing the pre-built board* and speaker into the plastic case and wiring up the stylus controller -- but it is such a simple design that it seems built to be hacked on, and that's what I wanted to do.

I did find a number of cool SX-150 hacks, but often they were a bit more advanced than I'm ready for, so I figured I'd start with something simple and slowly build on it and make this a multi-part project. Since I'm really enjoying getting into Arduino programming, an Arduino-based sequencer seemed like a good candidate -- so let's get started with part 1!

Read more »